Line bushings with terminals

for Zone 1

07-93..-..../.

Benefits

Space-saving construction as many single cores are gathered in one single sleeve thus requiring only one cable entry hole
As all 6 cores are brought out, direct Y-/\- switching. Is also possible on the motor terminal board of Ex d motors
Motor mains and thermoprotection cables can be exited in one common sleeve
Numbered cores simplify connections and eliminate the usual “Ring out“ in larger control systems
On the Ex d side, the cores are connected directly to the electrical load, intermediate terminals are no longer necessary
Small dimensions allow a rated insulation voltage of up to 3 kV
Blue cores for Ex i low power circuits
Permanent heat-resistance of the cores up to +110 °C

Get a Quote

Marking

ATEX:
Ex II 2G Ex db eb IIC Gb
Ex I M2 Ex db eb I Mb

IECEx:
Ex db eb IIC Gb
Ex db eb I Mb

Ambient Temperature

-60 °C ≤ Ta ≤ +110 °C
(-76 °F ≤ Ta ≤ +230 °F)
depending on the design, terminals and lead
(temperature ranges apply to the “permanent installation“ of the leads)

Certification

ATEX
- DE
- EN
IECEX
- EN
CCC
- ZZ
UKEX
- EN

Description

A line bushing is a component for the electrical connection between a flameproof “d“ enclosure and an increased safety “e“ terminal box. The bushing consists of a threaded or non-threaded metal sleeve encapsulating one or more cores providing a flameproof barrier. The lengths of these leads vary according to their applications. The depth of engagement of the threaded sleeves and the joint length of the cylindrical sleeve in the wall of the “d“ enclosure must correspond to the EN 60079-0 and EN 60079-1 standards. After installation the bushing must be protected against rotation and accidental loosening. Recommendations are given under “Accessories“. Our standard bushings come with threaded sleeves from M10 to M48 or with cylindrical sleeves. They are equipped with cores with a 0.2 to 95 mm2 csa. and approved for nominal voltages between 250 V and 3 000 V. See also table “Electrical data“.

For the connection of intrinsically safe circuits in the “d“ area with the terminal strip in the connection compartment we provide line bushings with blue cores for “i“ low power circuits.

Dimensions	see data sheet
Voltage	Nominal voltage: 690 V/1 000 V
Current	see data sheet
Connection	Number of terminals: 4 or 6 (depending on the cross-section) Cross-section: 0.75 mm²/1.5 mm²/2.5 mm²/4 mm²/6 mm² Sleeve size: metric: M24 x 1.5 to M42 x 1.5 non-threaded: ∅ 22 mm to ∅ 36 mm Sleeve material: metal, bare, varnished or galvanised